APPLICATION THAT’S EASY1

  • 1

    Blot Excess Blood
    Blot excess blood from the target bleeding site with gauze/pad or suction. The wound surface should be as dry as possible just before application.
  • 2

    Apply HEMOBLAST™ Bellows

    Apply HEMOBLAST™ Bellows to the bleeding site by compressing the bellows. Enough implant material (multiple layers, if needed) should be applied to cover the entire source of bleeding.
  • 3

    Hold Wet Lap Pad

    Immediately apply wound-appropriate pressure using a wet laparotomy pad. Hold for approximately 3 minutes. Gently lift the laparotomy pad and inspect the area.
  • 4

    Once Hemostasis is Achieved, Irrigate Excess
    Once hemostasis is achieved, excess powder should be removed from the site of application by irrigation and aspiration.

If hemostasis has not been achieved, repeat steps 1-3 or use an alternate method of hemostasis treatment.

 

Please refer to the Instructions for Use for full prescribing information.1

APPLICATION TECHNIQUE VIDEOS

1. HEMOBLAST™ Bellows Hemostatic Agent [instructions for use]. Biom’up SA.

Caution: Federal law restricts this device to sale on or by the order of a physician. The trademark of HEMOBLAST™ Bellows and SPOT GRADE™ are the property of Biom’up. The trademarks of the products listed herein are trademarks of their respective manufacturer. Please refer to the Instructions for Use accompanying each device for further information. The presentation contains pictures owned by third party and remains their property.
E-MR-318-V1
HEMOBLAST™ Bellows Hemostatic Agent [instructions for use: E-MR-217-V6]